A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Ayer, including rooms that have never had a ceiling fixture at all.
“Breaker had been tripping for months and two other companies just replaced parts. OSB traced it to a backstabbed outlet behind a bookcase in twenty minutes.”
“We had knob-and-tube in the attic and our insurer was getting nervous. They rewired in stages so we never lost power for more than a few hours at a time.”
“Bought an EV and had no idea what my panel could handle. They did the load calculation, told me straight that I had room, and installed the charger two days later.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Ayer home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Panel-mounted surge protective devices
See serviceCKT 100AStandby and whole house backup
See serviceCKT DIAGTroubleshooting and fault finding
See serviceCKT 60ALevel 2 and Tesla Wall Connector
See serviceCKT 3PHOffices, retail, restaurants, warehouse
See serviceCKT 14/2Knob-and-tube and aluminium replacement
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
This is the one electrical symptom that should never wait until morning.
ReadGUIDEThe decisions that cost fifty dollars during a renovation and two thousand afterwards.
ReadGUIDEThe old wiring in your attic, explained — plus what a staged rewire actually looks like.
Read