A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Rockland, including rooms that have never had a ceiling fixture at all.
“We had knob-and-tube in the attic and our insurer was getting nervous. They rewired in stages so we never lost power for more than a few hours at a time.”
“Sold our house and the buyer's inspector flagged eight electrical items. OSB fixed all of them in one visit and wrote it up so we could close on time.”
“Our panel was original to the house and completely full. OSB upgraded us to 200 amp, pulled the permit, met the inspector, and left the basement cleaner than they found it.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Rockland home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Automation, structured wiring, hubs
See serviceCKT 60ALevel 2 and Tesla Wall Connector
See serviceCKT SPDPanel-mounted surge protective devices
See serviceCKT 20AGFCI, USB, dedicated circuits
See serviceCKT 14/2Knob-and-tube and aluminium replacement
See serviceCKT DIAGTroubleshooting and fault finding
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
Spacing rules, colour temperature, and the mistake that makes a ceiling look like an airport.
ReadGUIDEThe old wiring in your attic, explained — plus what a staged rewire actually looks like.
ReadGUIDEThe decisions that cost fifty dollars during a renovation and two thousand afterwards.
Read