A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Boxford, including rooms that have never had a ceiling fixture at all.
“We had knob-and-tube in the attic and our insurer was getting nervous. They rewired in stages so we never lost power for more than a few hours at a time.”
“The dispatcher actually understood what I was describing on the phone and told me which breaker to shut off before they arrived.”
“The quote they gave me on the phone was the number on the invoice. That is apparently rare and it shouldn't be.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Boxford home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Recessed, outdoor, LED retrofit
See serviceCKT 60ALevel 2 and Tesla Wall Connector
See serviceCKT 200A100A to 200A service, breaker boxes
See serviceCKT SPDPanel-mounted surge protective devices
See serviceCKT 3PHOffices, retail, restaurants, warehouse
See serviceCKT 20AGFCI, USB, dedicated circuits
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
What to decide before you book a Level 2 charger install — and the load calculation that decides for you.
ReadGUIDEThe old wiring in your attic, explained — plus what a staged rewire actually looks like.
ReadGUIDEOverload, short circuit or ground fault — each has a different cause and a different fix.
Read