A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Feeding Hills, including rooms that have never had a ceiling fixture at all.
“Six recessed lights in the kitchen and a dimmer that actually works. The ceiling patch was so small I didn't need a painter.”
“Garage had one outlet and a light on the house circuit. Now it has a sub-panel and I can actually use my tools.”
“Lost a furnace board and a TV in one storm. They put a surge device on the panel and explained exactly what it does and doesn't cover.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Feeding Hills home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Automation, structured wiring, hubs
See serviceCKT 15ARecessed, outdoor, LED retrofit
See serviceCKT 60ALevel 2 and Tesla Wall Connector
See serviceCKT 200A100A to 200A service, breaker boxes
See serviceCKT SPDPanel-mounted surge protective devices
See serviceCKT 3PHOffices, retail, restaurants, warehouse
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
Overload, short circuit or ground fault — each has a different cause and a different fix.
ReadGUIDEThree legitimate fixes, one of which is far cheaper than a rewire.
ReadGUIDEWhat to decide before you book a Level 2 charger install — and the load calculation that decides for you.
Read