A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Grafton, including rooms that have never had a ceiling fixture at all.
“Our panel was original to the house and completely full. OSB upgraded us to 200 amp, pulled the permit, met the inspector, and left the basement cleaner than they found it.”
“Garage had one outlet and a light on the house circuit. Now it has a sub-panel and I can actually use my tools.”
“Two-prong outlets all through a 1920s house. They grounded what could be grounded and GFCI-protected the rest, then labelled everything.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Grafton home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Recessed, outdoor, LED retrofit
See serviceCKT 200A100A to 200A service, breaker boxes
See serviceCKT 3PHOffices, retail, restaurants, warehouse
See serviceCKT 100AStandby and whole house backup
See serviceCKT 24/7No power, sparks, burning smell
See serviceCKT CAT6Automation, structured wiring, hubs
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
Overload, short circuit or ground fault — each has a different cause and a different fix.
ReadGUIDEThree legitimate fixes, one of which is far cheaper than a rewire.
ReadGUIDEWhat to decide before you book a Level 2 charger install — and the load calculation that decides for you.
Read