A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Hampden, including rooms that have never had a ceiling fixture at all.
“Two-prong outlets all through a 1920s house. They grounded what could be grounded and GFCI-protected the rest, then labelled everything.”
“The dispatcher actually understood what I was describing on the phone and told me which breaker to shut off before they arrived.”
“Whole-house LED retrofit across our warehouse. Our lighting bill dropped and you can finally read labels on the top rack.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Hampden home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Panel-mounted surge protective devices
See serviceCKT 15ARecessed, outdoor, LED retrofit
See serviceCKT 24/7No power, sparks, burning smell
See serviceCKT 20AGFCI, USB, dedicated circuits
See serviceCKT 200A100A to 200A service, breaker boxes
See serviceCKT CAT6Automation, structured wiring, hubs
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
What to decide before you book a Level 2 charger install — and the load calculation that decides for you.
ReadGUIDEThree legitimate fixes, one of which is far cheaper than a rewire.
ReadGUIDEOverload, short circuit or ground fault — each has a different cause and a different fix.
Read