A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Sandwich, including rooms that have never had a ceiling fixture at all.
“Lost a furnace board and a TV in one storm. They put a surge device on the panel and explained exactly what it does and doesn't cover.”
“Every smart switch I bought failed because there was no neutral. They pulled neutrals in the rooms that needed it and set up the rest properly.”
“Six recessed lights in the kitchen and a dimmer that actually works. The ceiling patch was so small I didn't need a painter.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Sandwich home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Panel-mounted surge protective devices
See serviceCKT 200A100A to 200A service, breaker boxes
See serviceCKT 60ALevel 2 and Tesla Wall Connector
See serviceCKT 15ARecessed, outdoor, LED retrofit
See serviceCKT CAT6Automation, structured wiring, hubs
See serviceCKT DIAGTroubleshooting and fault finding
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
What to decide before you book a Level 2 charger install — and the load calculation that decides for you.
ReadGUIDEThis is the one electrical symptom that should never wait until morning.
ReadGUIDEOne protects people. One protects buildings. They are not interchangeable.
Read