A ceiling fan needs a fan-rated box, not a light box — that's the part most people find out the hard way. OSB installs and replaces fans throughout Prides Crossing, including rooms that have never had a ceiling fixture at all.
“Two-prong outlets all through a 1920s house. They grounded what could be grounded and GFCI-protected the rest, then labelled everything.”
“Every smart switch I bought failed because there was no neutral. They pulled neutrals in the rooms that needed it and set up the rest properly.”
“Our panel was original to the house and completely full. OSB upgraded us to 200 amp, pulled the permit, met the inspector, and left the basement cleaner than they found it.”
Replacing a fan where a fan-rated box already exists is a quick flat-rate job. Adding a fan to a room with no fixture costs more because it needs a box, a switch leg and a cable run.
Yes. Sloped-ceiling adapters and the right downrod length keep the blades level and clear.
You do — a fan-rated box that carries the moving weight. A standard light box isn't built for it and is the most common thing we replace.
Yes, with a three-wire run or a remote/smart control if fishing a new cable isn't practical in your Prides Crossing home.
We do, using damp or wet-rated fans on GFCI-protected exterior circuits.
Offices, retail, restaurants, warehouse
See serviceCKT 15ARecessed, outdoor, LED retrofit
See serviceCKT 14/2Knob-and-tube and aluminium replacement
See serviceCKT SPDPanel-mounted surge protective devices
See serviceCKT CAT6Automation, structured wiring, hubs
See serviceCKT 100AStandby and whole house backup
See serviceFlat pricing quoted before the work starts. Same-day and next-day slots available across Massachusetts.
Seven questions, and what a good answer to each sounds like.
ReadGUIDESizing, fuel, transfer switches, and the honest answer on whether you need whole-house coverage.
ReadGUIDEOverload, short circuit or ground fault — each has a different cause and a different fix.
Read